Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones Pagina 42

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 77
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 41
TABLE [4-1]: MAINTENANCE SCHEDULE
REF. SERVICE POINT DESCRIPTION
4-2
1 Labeling, Decals,
and Cleaning
- Ensure that the Rated Load Capacity decal is affixed properly, clearly
visible and legible. Replace if necessary.
- Ensure that all Operating Instruction decals are affixed properly,
clearly visible and legible. Replace if necessary.
- Ensure that serial number is clearly marked, legible and visible.
- After washing vehicle, spray lubricant, such as Curtisol Red Grease
#88167, on all carriage/lifting frame/platform/rollstop pivot points, and
rub down all surfaces with oil to avoid rusting of material.
THREE MONTH SAFETY CHECK (or @ 900 - 1000 cycles of operation)
1 Rollstop Pivot
Points
- Spray lubricant, such as Curtisol Red Grease #88167, on rollstop
pivot points. Wipe clean any excess grease from targeted areas and
surrounding areas.
2 Platform Guides
and Bridgeplate
Pivot Points.
- Spray lubricant, such as Curtisol Red Grease #88167, on sliding
platform guide rails and bridgeplate pivot points. Wipe clean any
excess grease from targeted areas and surrounding areas.
3 Hydraulic Fluid
Level
- Ensure that the hydraulic fluid level is maintained at the required "full"
level. Add only Texaco No. 15 aircraft hydraulic fluid (or equivalent
U.S. mil spec H5606E oil).
ANNUAL SAFETY CHECK (or @ 3600 - 4000 cycles of operation)
1 Hydraulic Pump
Unit
- Extract, refill, extract again, and refill the Hydraulic Unit Reservoir to
the required "full" line using Texaco #15 hydraulic fluid. Add only
Texaco No. 15 aircraft hydraulic fluid (or equivalent U.S. mil spec
H5606E oil).
2 Hydraulic
Cylinder/Flow
Control
Valve/Hoses,
Lines and Seals
If hydraulic fluid is low, inspect the following for evidence of leaks:
- Hydraulic Cylinder and Flow Control Valve.
- Ensure that hydraulic hoses are not damaged.
- Ensure that all seals are seated properly and all fittings are tightly
secured.
*RICON CORP. strongly recommends that this lift be refit after five years of use.
END OF TABLE
Vista de pagina 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 76 77

Comentarios a estos manuales

Sin comentarios