Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones descargar pdf (Pagina 19)

2-5

2. WIRING FOR OPTIONAL PUMP ENCLOSURE

For electrical installation of the optional pump enclosure, refer to Figure [2-4] and follow this

procedure:

FIGURE [2-4]: WIRING FOR OPTIONAL PUMP ENCLOSURE

a. Crimp the supplied ring terminals to the harness assembly as shown.

b. Route and connect the "Pump to Pendant Harness Extension" to the pump enclosure

assembly.

c. Attach the ring terminals to the terminal board as shown.

3. MAIN WIRING

Whether the vehicle electrical system is +12VDC or +24VDC, insulated return or chassis

ground, the electrical installation is similar. To install electrical power to the lift, follow this

procedure:

CAUTION

CHECK VEHICLE BEFORE DRILLING. DO NOT DRILL INTO FACTORY WIRING,

HYDRAULIC LINES, FUEL LINES, FUEL TANK, ETC.

a. At vehicle engine or battery compartment, mount supplied Main Circuit Breaker within 10 -

12" (25 - 30 cm) of battery.

b. Adjacent to lift hydraulic pump unit, drill one 3/4" (19.5-mm) hole through vehicle floor,

deburr hole, and install grommet.

c. Insert lift power cable harness through drilled hole.

CAUTION

WHEN ROUTING POWER CABLE, AVOID HAZARDS SUCH AS VEHICLE DRIVE

SHAFTS, MOVING SUSPENSION PARTS, EXHAUST SYSTEMS, ETC.

d. From beneath vehicle, run harness along vehicle frame to circuit breaker. Make sure

harness does not interfere with moving or hot parts and secure with cable ties every 18" (45

cm).

e. At engine compartment, cut and retain 12" (30 cm) section from end of harness RED wire.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 76 77

Sin comentarios

Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones Pagina 19