Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones descargar pdf (Pagina 15)

2-1

II. INSTALLATION

he RICON Eclipse® F8000 (A) Series Export Use Wheelchair and Standee Lift is installed in a

cassette mounted to the underside of the vehicle and behind the bottom step riser. Due to the

wide range of applications for the lifts, it is impossible to provide specific information about every

possible installation. The following general procedures will apply to many installations. Contact the

Ricon Product Support Department for instruction about installations not covered. To install the lift, refer

to the following sections and perform the procedures carefully and in the order that they are presented.

Be certain that the installation instructions are followed exactly and do not eliminate any steps or modify

the product.

A. MECHANICAL

To install the lift, follow this procedure:

1. LIFT LOCATION

The location of the lift depends on the motion path of the platform. The lift must be located so

that the platform can move unobstructed through its required range of travel.

2. LIFT MOUNTING

a. Refer to Figure [2-1]. Mechanical support of the lift will be provided at four (two on each

side) attachment points. Each attachment point consists of two 5/16-18 tapped bolt inserts.

FIGURE [2-1]: LIFT MOUNTING ATTACHMENT POINTS

b. Since lift mounting varies from one model to another, the vehicle mounting brackets for

attachment of the lift are not supplied. When fabricated, the mounting brackets must meet

the criteria listed in Table [2-1].

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 76 77

Sin comentarios

Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones Pagina 15