Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones descargar pdf (Pagina 25)

2-11

4. DEPLOY LOCK SETTING

The following procedure provides for setting the deploy lock position of the lift carriage

assembly at full deployment. The proper deploy lock position is determined by the gap distance

between the lift enclosure deploy lock striker and the lift carriage deploy lock latch bar, and is

adjusted by setting two (2) carriage stop block set screws located inside the lift enclosure

assembly at the front of the lift.

a. Refer to Figure [2-9]. Deploy the lift normally as described in the Operating Instructions

chapter of this manual. The deploy lock handle should be in its upright position, with the

(spring-loaded) deploy lock latch bar engaged by the deploy lock striker.

FIGURE [2-9]: DEPLOY LOCK ADJUSTMENT

b. Determine how much adjustment is required, then stow the lift. The distance between the

deploy lock latch bar and striker should be no more than 1/16". If the distance is out of

tolerance or the deploy lock mechanism does not engage properly, continue with this

adjustment procedure.

c. From the front of the lift with the carriage fully stowed, gain access to the left/right carriage

stop blocks attached to the enclosure assembly mounting frame channels.

d. With a long allen wrench, turn the stop block set screws clockwise to decrease the gap

distance, or counter-clockwise to increase the gap distance. One (1) full turn is equivalent

to 1/16" of adjustment. Be sure to adjust set screws simultaneously an equal number of

turns.

e. Repeat check procedure as described in the above section and adjust set screws as

required until the proper gap distance is achieved. Stow and deploy the lift several times

to ensure proper operation.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 76 77

Sin comentarios

Eclipse Combustion F8000 Series Service/ Instrucciones de operaciones Pagina 25